(Use if printer shipped before Nov 2016, otherwise, file is provided in your manual). Use this file to print a few test layers and to load the "GCODE profile" needed for printing. Note: this file is only to used to print a few test layers; it covers a very small square footage, therefore, setting time between layers will be minimal. It is only to test a few layers (<10).


Use this illustrated step by step guide to getting started with the software Vesta relies on.


Use this software package to turn a 3D model (.STL, .3MF and .OBJ) into the .GCODE file which the Vesta Printer will use to physically print the model.


Use this software package to load a .GCODE file made in the Cura Engine and to begin, pause, and stop prints.